Automatic rotor wedge slot paper insertion machine
Basic Info
Model No.: ND-LSI-2WB
Product Description
This Automatic rotor wedge slot paper insertion machine is equipped with a touch screen. All the related parameter can be displayed and shown. The wedge material and dimension can be as per customer's requirement. We also provide design service. This machine is easy to operate and it suits different armature types by changing the tooling.
Technical Parameter
| Outside Dimension | 910*880*1300(L*W*H)mm |
| Equipment Weight | 250 Kg |
| Motor Power | 0.75 Kw |
| Work Voltage | 380 VAC |
| Work Air Pressure | 0.4-0.6 hMp |
| Manufacturing Product | Motor Rotor Insulated Paper |
| Rotor O.D. Range | φ20-φ55 |
| Length of Insulation Paper | 15-60 mm Adjustable |
| (MAX) Width of wedge | 25 mm |
| Rotor Slot number | 8-24 slots |
| Work procedure | Feeding-install fixture-plug in discharge |
| Fixture | Pneumatic Mechanical Fixture |
| Feeding form | Automatic |
| Lubricant form | Grease lubrication |
Preparation before installment
Ensure the space is enough for the equipment operation with the dimension of 2330X1550X1450 (including the feeding guide way);
The installment floor should be strong and flat enough;
The power supply is AC 380V and the air pressure is 0.4~0.6Mpa;
Install support Mat: Put the equipment at required place and then adjust the height of the four support mat to 100mm, until there is no any vibration happen and finally tighten the screw of support mat;
Check whether the transferring parts, lock screw and the wire in the power controller are loose or not;
Malfunctions and Troubleshooting
| Malfunction | Check |
|
A．Equipment not run even press start button
| n Power and air supply |
| n Make sure all input signal from sensor are correct, travel switch (X10) is pressed, no signal from counter sensor (X2), push bar protector (X7) and no paper sensor(x6) and full feeding (X4). Also, there is signal from the mechanic hand (X0) and magnetic sensor (X1) of small cylinder. | |
| n Brake is power off or not | |
| n The feeding sensor(X3) should have signal if there is rotor on the guide way. | |
| n Check cylinder and air pipe, make sure the pressure is between 0.4 and 0.6MPa | |
| B. Fail to feed paper | n Check whether the paper is jammed in the feeding or discharging part, whether the upper press wheel is down pressed |
| C. No action or improper action in big cylinder | n Make sure the air pressure is 0.4 -0.6MPa |
| n Check whether the magnetic valve is functional. | |
| n Adjust the release valve of feeding cylinder to 0.3 Mpa | |
| D. Incorrect work indexing | n Adjust indexing screw |
| E. No action in small cylinder | n Check whether the mechanical valve is down pressed. |
| F. The position is not correct after reset | n Adjust the counter sensor screw and make sure it is on the right position after reset. |
|
G. Paper jam
| n If it was blocked in the forming tooling, the equipment would stop because of the protective switch on duty. If it was blocked behind the upper press wheel, press the stop button, now the mechanical hand still hold the rotors, press the single/automatic button to adjust it to manual, the mechanical hand will release the rotor, then take out the paper, and reset, adjust the button to automatic, and start the equipment. |
Product Categories : Armature Manufacturing Machine > Wedge Inserting Machine